Dialogic IMG 1004 Configure GCEMS and Start Linux Services - IMG 1004

Installation and Setup
120
Configure GCEMS and Start Linux Services - IMG 1004
Topic Location:
IMG 1004-Installation and Setup Guide > IMG 1004-Software Installation and Setup
Before You Begin:
 The IMG 1004 should be unpacked, mounted, and connected power to the GCEMS server.
See the manufacturer's instructions for installation procedures.
 The GateControl EMS software must be installed. See Installing GCEMS Software.
 Acquire IP Addresses for the IMG 1004.
 Acquire the MAC address of the IMG 1004 from tag on rear of unit.
Procedure:
Follow these steps to setup the GCEMS Server.
1. Connect to the GCEMS Server.
2. Login as:
user: excelsw
password: excelsw
3. If a DNS server will be needed in your network you will need to configure a DNS server.
To configure DNS server on GCEMS server follow next few steps.
4. In the RedHat GUI select System Settings > Network and the following screen below will
appear.
5. Select the DNS tab and enter a hostname for the DNS server in the Hostname field.
6. Enter Primary and Secondary IP addresses for the primary and secondary DNS servers.
7. Close the network configuration screen.