Digi MIL-3200X manual T a L L

				Chapter 2
			Table 2-1:Operating Mode
	D3	D4	Mode	Description
Up		Up	Normal	Does not allow a Telnet session. Users can print to the
				unit. The SYS (system) LED and NET (network) LED blink.
Down		Up	Telnet Diagnostic	Allows a Telnet session to monitor FastPort or change its
			Monitor	parameters. Users can print to the unit. The SYS LED and
				NET LED blink.
Down		Down	Serial Diagnostic	A terminal can be attached to serial port 2 to run a serial
			Monitor	monitor. Print jobs are not accepted. The NET LED blink.
Up		Down	Test Page	A test page prints on a power cycle. No print jobs are
				accepted.

I

N S T A L L

1SERIALPARALLEL

FASTPORT TM

4 PORT NETWORK PRINT SERVER

MODEL MIL•3200X

S1S2

1	2	3	4
P2			P1

PARALLELSERIAL 2

A

T

I

O N

Figure 2-1. MIL-3200X Front Panel

Table 2-2: Flash and Test Page Select

Switch	Position	Mode	Description
D1	Up	Flash	Selects bank 0 (upper) to run the 4 Mb Flash EPROMs for
		Bank	uploading the new firmware image.
	Down		Selects bank 1 (lower) to run the 4 Mb Flash EPROMs for
			uploading. If the upgrade process fails, use this setting and
			power cycle the unit to return FastPort to its default settings.
D2	Up	Test Page	MIL-3200X selects parallel port 2 and serial port 2 for test page
			printing.
	Down		MIL-3200X selects parallel port 1 and serial port 1 for test page
			printing.

Table 2-3: Default Settings

D1	D2	D3	D4
Up	Down	Down	Up

MIL-3200X Series of FastPort Print Servers 2-3