4
Quick Install Procedure
This section will guide you through the quick installation of the iSwitch.
1. Install mounting brackets: page 4.
2. Install all input and output connections: pages 5 and 6.
3. Program you IP address: page 9.
For USB setup:
a) Insert Driver Setup Diskette in floppy drive.
b) Run Setup.exe from floppy drive.
c) Program IP address per Page 15.
d) Program Subnet mask per Page 15.
e) Program Default Route per Page 15.
f) Program DNS Server per Page 15.
g) Note: Default user name is: admin.
h) Note: Default password is admin.
At this point the unit is operational: Review the (section Quick Install) pages 4-7 to become familiar with the
general functions. Review the entire User’s Manual in detail for more in-depth functions.
4. Set iSwitch’s front control buttons for Internet/remote
5. Use browser to monitor and control.
6. Note: Smart phone default password must include # as last character
7. For NT shutdown setup, use control panel / UPS configure.
a) RJ11 connections on the rear panel are disconnected if they contain a plug in the housing.
The iSwitch comes with brackets for mounting in a standard 19-inch rack. To mount the iSwitch into a rack
perform the following procedure:
1. Attach the mounting brackets to the unit as shown, using the four retaining screws provided for each of the
brackets.
2. Choose a location for the brackets. A notched hole on the vertical rail denotes the middle of a U slot.
3. Align the mounting holes of brackets with the notched hole on the vertical rail and attach with the retaining
screws.