Digital Stream F1-FOX Service Search OSD , Found services OSD

Motorized System

It is used to set the DiSEqC 1.2 motor by Eutelsat specifica-

tion. If you wish to use this system, please refer to page 34

for instructions.

Service Search OSD

If you press the EXIT key during the search, service

search stops and the searching menu appears.

When you find all the services the following picture

appears.

Before saving it, you can select the service you want to

delete.

The picture above shows services that are found after

manual search.

You can mark the services that you don’t want to save

using the (red) key, these services will turn grey. To

unmark a service, select the service and press the (red)

key on it again.

Press the OK key to save, or press the EXIT key to exit

without saving.

Then Manual Search menu appears. When you exit all

menus, the first service of the found service list is played.

In the bottom of found service picture, network, the informa-

tion of transponder and the number of found service that the

services belong to are displayed. The deleted service by the

(red) key is excepted from counting of the number of

sevices.

At the bottom of the screen that shows the services found in

the search, the information of transponder and the number of

found services that the service belongs to are displayed. The

deleted service (using the (red) key) is not included in this

number.

Free means the empty part of all service memory, this is the

amount of space available to store other services in the

future.

Guide of

Main Menu