12 www.dimplex.com
To turn the heater off, rotate the
knob fully counter clockwise.
Resetting the Temperature Cutoff Switch
This unit is equipped with a
thermostat which controls the
temperature of the room by
turning the heater on and off. The
heater is protected with a safety
device to prevent overheating.
should the heater overheat, an
automatic cut out will turn the
heater off and it will not come
back on without being reset. It
can be reset by switching the
Three Position on/off switch to
off and waiting ve (5) minutes
before switching the unit back on.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call
Technical support at 1-888-
346-7539. Please have your
model and serial number
ready when calling.
Remote Control (Figure 6)The replace is supplied with an
integrated on/off remote control.
! NOTE: Ensure that the
Three Position On/Off
Switch on the replace is set
to the remote control setting
(“ II ”position).
To operate, push the on button
to turn the replace on, push the
oFF button to turn the replace
off.
Battery Replacement (Figure 6)
To replace the battery:
• slide battery cover open on
the hand held transmitter.
• Correctly install one (1) 12 Volt
(A23) battery in the battery
holder.
• Close the battery cover.
Remote Initialization/
Reprogramming
Follow these steps for remote
control initialization and if
required, re-initialization:
Disconnect power to 1.
replace.
set the Three Position on/off 2.
switch to the remote position
(Figure 5A).
Wait a minimum of ve (5) 3.
seconds and then re-acquire
power to replace.
Within4. 10 seconds of re-
acquiring power, press the
Operation