Dimplex DF2608 owner manual Important Only handle

Maintenance

Figure 7
	Trim
Log Set	Front
Assembly	Glass

the number of times you need to open the unit to replace light bulbs. Care must be taken when removing the Log set assembly as it contains LED’s and wires (DF2608 only).

1.Slide fireplace out of mantel.

2.Lay unit on it’s back for safe removal of front glass.

3.Remove three (3) Phillips screws from the right side of trim.

4.Remove trim.

5.Slide glass to right side of fireplace to remove (Figure 7).

6.Pull the front edge of the plastic ember bed or plastic grate up and forward until the rear tab releases from the ledge located at the bottom of the mirror (Figure 8).

!IMPORTANT: Only handle

Figure 8	Log
	Ember Bed
Back
Ledge
Rear
Tab	Front
Side Section
	Edge

the log set assembly by the ember bed or plastic grate.

!NOTE: Log set assembly fits tightly into firebox, some force may be necessary to remove.

7.Set log set assembly in front of fireplace.

8.Remove flicker rod by pulling rod to the right, towards the flicker motor. Bend the flicker rod enough to clear the bracket on the left, lift out and pull flicker rod off of flicker motor shaft (Figure 9).

9.Remove four (4) Phillips screws (two (2) per side) which attach light filter bracket for easier access to light bulbs (Figure 9).

10.Unscrew bulbs counter clockwise to remove.

11.Insert new bulbs and screw in

14 www.dimplex.com