Dimplex DF3015 manual Upper Light Bulb Requirements, Do not Exceed 25 Watts PER Bulb

To access the lower light bulb area:

NOTE	Upper Light
Figure 7	Pannel

1.Slide fireplace out of mantel 2-3 inches.

2.Remove 4 Phillips screws from the right side of trim.

3.Slide glass to right side of fireplace to remove.

4. Pull the front edge of the plastic ember bed or plastic grate up and forward until the rear tab releases from the ledge located at the bottom of the mirror.

IMPORTANT

Only handle the logset by the emberbed.

NOTE		Logset	Lower
Logset fits tightly into firebox, some
			Bulbs
	force may be necessary to remove.
			LED Wire
5.	Set logset in front of fireplace.
			Harness
6.	Disconnect the logset LED wire harness
	from unit.
7.	Unscrew bulbs counter clockwise.
8.	Insert new bulbs.
9.	Reconnect the logset LED wire harness.

10. Replace the logset by inserting the front edge of the fireplace and push down on the rear edge of the emberbed until it snaps into place. (Figure 8)

NOTE

Ensure the logset is installed tightly under the

back ledge to prevent light leakage.FIGURE 8 11. Slide front glass back into position and attach trim.

UPPER LIGHT BULB REQUIREMENTS

Quantity of 2 clear chandelier or candelabra bulbs with an E-12 (small) socket rating.

DO NOT EXCEED 25 WATTS PER BULB

To access the upper light bulb area:

Figure 7

1.Slide fireplace out of mantel 2-3 inches.

2.Remove 4 Phillips screws from right side of trim.

3.Remove trim.

4.Slide glass to the right side of the fireplace to remove.

5.Remove upper light panel.

6.Upper bulbs located in the upper left and upper right corners of fireplace.

7.Unscrew bulbs counter clockwise. Insert new bulbs.

8.Re-install upper light bracket.

Slide front glass back into position and attach trim.

Upper

Bulbs

FIGURE 7

Front

Glass Trim

base, 25 watt

10