FIREPLACE INSTALLATION
1.Install the fireplace assembly into the mantel. (refer to mantel assembly instructions)
NOTE 1
A 15 AMP, 120 VOLT circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if, after installation, the circuit breaker trips or fuse blows on a regular basis when the heater is operating. Additional appliances on the same circuit may exceed the current rating of the circuit breaker.
IMPORTANT
If not using a Dimplex mantel, the fireplace must be installed in an enclosure with the following MINIMUM internal/opening dimensions.
NEW WALL CONSTRUCTION
1.Select a suitable location that is not susceptible to moisture and is away from drapes, furniture and high traffic.
2.Place the fireplace in the desired location to see how it will look in the room.
3.Mark the desired location on the floor and store the fireplace in a safe, dry and dust free location.
4.Use studs to frame an opening of 30 ½” wide X 25 ¾” high X 11 ¾” deep.
Option
Option
Plug the unit into a 15Amp/120Volt outlet. If the cord does not reach, you may use an extension cord rated for a minimum of 1875 watts.
4