RESETTING THE TEMPERATURE CUTOFF SWITCH
Should the heater overheat, an automatic switch will turn the heater off and it will not come back on without being reset. The temperature cutoff switch can be reset by unplugging the unit, waiting 5 minutes and plugging the unit back in.
CAUTION
If you need to continuously reset the heater, unplug the unit and call Dimplex North America Limited at
REMOTE CONTROL
The remote control has a range of approximately 50 ft. (15.25m), it does not have to be pointed at the fireplace and can pass through most obstacles (including walls). It is supplied with 243 independent frequencies to prevent interference with other units.
BATTERY INSTALLATION
1.Depress tab on the battery cover on the back of the remote transmitter and remove battery cover.
2.Install 2 AAA batteries into the remote control. (included)
3.Ensure child lock is in the “unlocked” position.
4.Replace the battery cover.
Batteries
FIGURE 3
NOTE
When the “BAT” symbol is present on the remote control it is recommended to replace the batteries promptly, to maintain full functionality of the remote/fireplace. The remote transmitter has a battery backup time of only several hours.
INITIALIZING THE REMOTE CONTROL
1.Plug cord into 120 volt wall outlet.
2.Ensure the Main On/Off switch located in the switch box on the fireplace in the lower
right hand corner is in the |
| ON position. |
|
3.Set the 3 position manual control to the Remote position (right position).
4.Press and hold the initialization button on the unit.
5. | While holding the initialization button, press the flame/heat ON/OFF | button or the | ||
| Purifire™ ON/OFF | button on the remote control transmitter. |
| |
6. | Release the initialization button on the unit. |
| ||
7. | Press the Flame/Heat On/Off button to turn the Flame/Heat function ON or press the | |||
| Purifire™ On/Off button | to turn the Purifire™ function ON. |
|
6