FREQUENCY INTERFERENCE
If the fireplace does not respond properly to the remote control, the remote operating frequency may have to be reset. The remote control can send another frequency code to the circuit board to eliminate interference.
1.Simultaneously press the “SLEEP TIMER DOWN” button and the “PURIFIRE LOW SPEED” button on the remote control.
2.“COD” will appear in place of the sleep timer digits.
3.Release the “SLEEP TIMER DOWN” button and the “PURIFIRE LOW SPEED” button.
4.Press the initialization button on the unit.
5. press the button on the remote.
Your remote will now have a different frequency communicating with the fireplace.
REMOTE CONTROL FUNCTIONS
| Room Temperature | |
| Set Temperature | |
Temperature | Temperature Up | |
Dimmer Up | ||
Down | ||
Dimmer | Dimmer | |
Down | Flame Speed Up | |
Flame Speed | ||
Flame Speed Control | ||
Down | ||
Sleep Timer | Sleep Timer Up | |
Down | Sleep Timer | |
Purifire Low | ||
Purifire High Speed | ||
Speed | ||
| Purifire | |
Flame & Heat | Purifire On / Off | |
On / Off |
FIGURE 5
Batteries
Child Lock
FLAME/HEAT ON/OFF BUTTON
Press the “Flame/Heat On/Off “button to turn the Flame/Heat function ON. When the “Set Temperature” is higher then the “Room Temperature” the heat will come on. To turn the heat off, lower the “Set Temperature” so that it’s setting is lower then the “Room Temperature”. The default temperature setting is 72°F (22°C).
NOTE
When using the remote control the heater runs on a thermostat. Press the “Temperature Up” or “Temperature Down” button to adjust the set temperature. Once the desired set temperature is reached the heater will turn OFF. The heater will cycle ON and OFF to maintain the desired set temperature.
7
