!NOTE: To temporarily unlock the remote transmitter press (in order) I - Temperature Down then J - Temperature Up then K - Dimmer Down/Firelight Off.
When the remote transmitter’s backlight is illuminated the Child Lock is bypassed. When the backlight is off the Child Lock is
Frequency Interference
If the fireplace does not respond properly to the remote control, the remote operating frequency may have to be reset. The remote control can send another frequency code to the circuit board to eliminate interference.
1.Simultaneously press the O - Slow Start/Fading Embers Off button and the Q - Purifire™ Low Speed button on the remote control.
2.“CODE” will appear.
3.Release the Slow Start/Fading Embers Off button and the Purifire™ Low Speed button.
4.Press and hold the Initialization Button on the unit (Figure 4).
5.Press the G - Flame & Heat On/Off 
button on the remote and release the Initialization Button.
Your remote will now have a different frequency communicating with the fireplace.
Maintenance
WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons.
Light Bulb Replacement
Allow at least five (5) minutes for light bulbs to cool before touching bulbs to avoid accidental burning of skin.
Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log ember bed exterior disappears. There are four (4) bulbs under the log set, which generate the flames and embers, and two (2) bulbs above the log that illuminate the log exterior.
16
