Dimplex DF3215NH owner manual Purifire Filter Figure, Upper Light Bulb Requirements

8.Insert new bulbs.

9.Install the left side of the flame rod to the mounting bracket.

10.Reconnect the Log Set LED Wire Harness.

11.Replace the Log Set by inserting the rear tab of the Ember Bed under the mirror and push down on the front edge of the Ember Bed until it snaps into place (Figure 9).

!NOTE: Ensure the Log Set is installed tightly under the back ledge to prevent light leakage.

12.Close the Bi-fold doors.

Figure 9

Back		Log
Ledge		Ember
		Bed
Rear	Side Section	Front
Tab		Edge

Upper Light Bulb Requirements

Quantity of two (2) clear chandelier or candelabra bulbs with an E-12 (small) socket base, 25 Watt rating.

Do not exceed 25 Watts per bulb.

To access the upper light bulb area:

1.Open the Bi-fold doors.

2.Remove upper light bracket with a screwdriver (Figure 10).

3.Replace bulb.

4.Reassemble in the reverse order as above.

Purifire™ Filter (Figure 11)

Figure 10

Upper Light

Screw

Upper Light Bracket

The Purifire™ filter supplied in your fireplace is reusable and washable. The filter should be cleaned or replaced on average once a year.

To clean the filter gently tap filter on a hard surface to dislodge any loose dirt or debris, and then clean with water. No soap or cleaning products are recommended. The filter size is 20 inches x 10 inches

18