Dimplex Optiflame Electric Fireplace manual Operation, Remote Control Initialization

OPERATION

FIGURE 1

FIGURE 2

REMOTE CONTROL

NOTE: If the fireplace turns on or off without input from the hand held remote or does not respond to the hand held remote control, see section A. Remote Control Initialization. If the unit continues to operate erratically contact customer service as a new hand held with a different frequency may be required.

The Optiflame fireplace is supplied with a radio Frequency remote control. This remote control has a range of approximately 50ft. (15.25m), it does not have to be pointed at the fireplace and can pass through most obstacles (including walls). It is supplied with one of 2178 independent frequencies to prevent interference with other units. The frequency designation is indicated on the back of the transmitter (FIGURE 1).

A. Remote Control Initialization

This procedure is required every time there is a loss of power to the remote control in the fireplace (i.e. power failure, breaker tripped, main power switch is turned off)

1.Ensure that power is supplied through main service panel.

2.Access the manual controls, (remove glass doors if applicable) pull right hand edge of right hand steel curtain towards the center of unit. (FIGURE 2)

3.Locate manual controls refer to FIGURE 3.

4.Activate main power switch, red indicator light 1 will flash.

5.Press and hold the heater control switch for five seconds. The second red indicator light will flash.

6.Press ON button located on the remote control transmitter (FIGURE 1). This will synchronize the remote control transmitter and receiver.

3