Dimplex Optiflame Electric Fireplace manual Accessories, To access the light bulb area

To access the light bulb area:

FIGURE 4

FIGURE 5

1.Open steel curtain (remove glass doors if applicable). The bulbs can be accessed from either side of the fireplace.

2.Remove two screws on log bracket and remove log plate (FIGURE 4).

3.Pull rear edge of ember bed up and forward by grasping ember bed by the sides (handle the logset only by the emberbed and not the logs) and pulling solidly until the rear tab pops out from under the back ledge, then lift out. (FIGURE 5)

4.Examine the bulbs to determine which bulbs require replacement.

5.Unscrew bulbs counter clockwise.

6.Insert new bulbs.

7.Replace the log by inserting front edge and under back ledge (FIGURE 5) and the logs are resting against mirror.

8.Replace log bracket using two screws previously removed.

Mirror Cleaning:

The mirror is cleaned in the factory during the assembly operation. During shipment, installation, handling, etc., the mirror surface may collect dust particles; these can be removed by buffing lightly with a clean dry cloth.

To remove fingerprints or other marks, the mirror can be cleaned with a damp cloth using good quality household glass cleaner. The mirror should be completely dried with a lint free cloth or paper towel.

CAUTION

•Do not use abrasive cleaners on mirror surface or spray liquids directly onto any surface.

ACCESSORIES

Please contact your local dealer for genuine Dimplex accessories. Example: Glass door kits, brass trim, cabinets designed to fit your Optiflame fireplace.

6