Operation
Resetting The
Temperature Cutoff
Switch
Should the heater overheat, an automatic cut out will turn the fireplace off and it will not come back on without being reset. It can be reset by switching the Main On/Off Switch to OFF and waiting five (5) minutes before
Battery Replacement (Figure 10)
To replace the battery:
①Slide battery cover open on the hand held transmitter.
②Install one (1) 12 Volt (A23) battery in the battery holder.
③Close the battery cover.
Figure 10
switching the unit back on.
CAUTION: If you need to continuously reset the heater, disconnect power and call Dimplex customer service at
Remote Operation
On
Button 
Off
Button
Battery
Battery
Cover
The fireplace is supplied with an integrated on/off remote control
!NOTE: Ensure that the fireplace Main ON/OFF Switch is set to the remote control setting.
To operate, push the ON button to turn fireplace on, push the OFF button to turn the fireplace off.
Battery must be recycled or disposed of properly. Check with your Local
Authority or Retailer for recycling advice in your area.
15
