WARNING: THIS APPLIANCE MUST BE EARTHED
REAR ENTRY OF CABLE
Fixed or flexible cable to be connected direct to the terminal block, cable gland not utilised.
BOTTOM ENTRY OF CABLE
Use the cable gland. Loosen
DO NOT SWITCH ON UNTIL THE INSTALLATION IS COMPLETE AND THE CASE AND TAP ARE IN PLACE
WATER CONNECTION
NOTE: Although it will not harm the boiler, it should not be operated with the water supply turned off.
The water supply must have a pressure not exceeding 7 Bar (700kpa) and no lower than 1 Bar (200kpa). If the mains water pressure is below1 Bar a fault situation could arise as described in section; “Temperature Control and Safety
If your water pressure exceeds 7 Bar, a suitable pressure reduction valve will need to be fitted to the water supply to bring it to a level that the machine can cope with. Failure to do this could result in the boiler overfilling .
The manufacturers cannot be held responsible for any machine malfunction if the water pressure exceeds that stated. If in doubt, consult your water supply company.
The boiler has a type B air gap in compliance with water bylaws and has both WRAS and KIWA approval.
Please note that washing machine hoses are not suitable for drinking water and will cause a very bad taste to the water.
A 15mm stop valve should be fitted between the water supply and the boiler so that the machine can be isolated. Water purification filters are available to ensure fresh tasting water. Please contact the service department for details on 01704 502911. In hard water areas scale can cause problems. Fitting a scale reducer will help minimise scale.
We regret that the manufacturers cannot be held responsible for scale problems even if a scale reducer has been installed.
4
