Lenovo 981, 992, 1008 Miscellaneous error messages, Message/Symptom FRU/Action, Display/Monitor

Table 2. ThinkServer EasyStartup DVD (continued)

•Follow the suggested actions in the order in which they are listed in the Action column until the problem is resolved.

•See the Chapter 7 “Parts Listing, TS200v Machine Types 0981, 0992, 1008, and 1010” on page 59 to determine which components are customer replaceable units (CRUs) and which components are field replaceable units (FRUs).

Symptom	Action
The EasyStartup	Make sure that the operating-system medium is supported by the EasyStartup program.
program will not start	See the EasyStartup User Guide for a list of supported operating-system versions. The
the operating-system	EasyStartup User Guide and compatibility notes are available through the EasyStartup
medium.	program.

Miscellaneous error messages

Message/Symptom	FRU/Action
Changing display colors	Display/Monitor
Computer will not power-off. See “Hard disk drive boot	1. Power Switch
error” on page 16.	2.	System Board
	3.	Riser card, if installed.
Computer will not RPL from server	1. Ensure that network is in startup sequence as first
		device or first device after diskette.
	2.	Ensure that network adapter is enabled for RPL.
	3.	Network adapter (Advise network administrator of
		new MAC address)
Computer will not perform a Wake On LAN® (if applicable)	1. Check power supply and signal cable connections
		to network adapter.
	2.	Ensure that the operating system settings are set to
		enable Wake on LAN.
	3.	Ensure Wake On LAN feature is enabled in
		Setup/Configuration (see “Starting the Setup Utility
		program” on page 77)
	4.	Ensure network administrator is using correct MAC
		address.
	5.	Ensure no interrupt or I/O address conflicts.
	6.	Network adapter (advise network administrator of
		new MAC address)
Dead computer. See “Hard disk drive boot error” on page	1. Power Supply
16.	2.	System Board
Diskette drive in-use light remains on or does not light	1. Diskette Drive
when drive is active.	2.	System Board
	3.	Diskette Drive Cable
Blank screen except for flashing cursor.	1. System Board
	2.	Primary Hard Disk Drive
	3.	Hard Disk Drive Cable
Incorrect memory size during POST	1. Run the Memory tests.
	2.	Memory Module
	3.	System Board

Chapter 4. Diagnostics 19