Lenovo 992, 981, 1008, 1010 manual Updating the server configuration

Figure 35. Reinstalling the server cover

5.Install the screws to secure the server cover.

6.Lock the server cover if you have a server cover lock.

7.Reconnect the external cables and power cords to the server. See “Front view” on page 23 and “Rear view” on page 23.

8.Depending on the parts you installed or replaced, you might need to confirm the updated information in the Setup Utility program. Refer to Chapter 8 “Configuring the server” on page 77.

Note: In most areas of the world, Lenovo requires the return of the defective FRU. Information about this will come with the FRU or will come a few days after the FRU arrives.

Updating the server configuration

When you start the server for the first time after you install or remove an internal option or external device, you might receive a message that the configuration has changed. The Setup Utility program starts automatically so that you can save the new configuration settings.

Some options have device drivers that you must install. For information about installing device drivers, see the documentation that comes with each option.

You can obtain device drivers for operating systems that are not preinstalled at http://www.lenovo.com/support. Installation instructions are provided in readme files with the device-driver files.

58ThinkServerHardware Maintenance Manual