Lenovo 981, 992, 1008, 1010 manual Removing and reinstalling the front bezel

Figure 5. Removing the server cover

Removing and reinstalling the front bezel

Attention

Do not open your server or attempt any repair before reading and understanding the Chapter 1 “About this manual” on page 1 and the Safety Information book. To obtain a copy of the Safety Information book, go to:http://www.lenovo.com/support

This section provides instructions on how to remove and reinstall the front bezel.

To remove and reinstall the front bezel, do the following:

1.Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the server.

2.Remove the server cover. See “Removing the server cover” on page 30.

3.Remove the front bezel by releasing the three plastic tabs on the left side and pivoting the front bezel outward.

Chapter 6. Replacing FRUs 31