Chapter 3. General Checkout
Attention
The drives in the servers you are servicing might have been rearranged or the drive startup sequence might have been changed. Be extremely careful during write operations such as copying, saving, or formatting. Data or programs can be overwritten if you select an incorrect drive.
General error messages appear if a problem or conflict is found by an application program, the operating system, or both. For an explanation of these messages, refer to the information supplied with that software package.
Before replacing a FRU, ensure that the latest level of BIOS is installed on the system. A
Use the following procedure to help determine the cause of a problem:
1.Turn off the server and all external devices.
2.Check all cables and power cords.
3.Set all display controls to the middle position.
4.
5.Turn on the server.
•Look for displayed error codes
•Listen for beep codes
•Look for readable instructions or a main menu on the display.
If you did not receive the correct response, proceed to step 6 on page 11.
If you do receive the correct response, proceed to step 7 on page 11.
6.Look at the following conditions and follow the instructions:
•If you hear beep codes during POST, go to “Beep symptoms” on page 16.
•If the server displays a POST error, go to “POST error codes” on page 17.
•If the server hangs and no error is displayed, continue at step 7 on page 11.
7.Run the Diagnostic programs. See Chapter 4 “Diagnostics” on page 13.
•If you receive an error, replace the part that the diagnostic program calls out.
•If the test stops and you cannot continue, replace the last device tested.
Problem determination tips
Due to the variety of hardware and software combinations that can be encountered, use the following information to assist you in problem determination. If possible, have this information available when requesting assistance from Service Support and Engineering functions.
•Machine type and model
•Processor or hard disk drive upgrades
•Failure symptom
–Do diagnostics indicate a failure?
–What, when, where, single, or multiple systems?
–Is the failure repeatable?
–Has this configuration ever worked?
© Copyright Lenovo 2010, | 11 |
