Figure 32. Installing the front fan assembly
7.Connect the new front fan assembly cable to the power fan connector on the system board. See
8.Reinstall the secondary hard disk drive if removed. See “Replacing the secondary hard disk drive” on page 40.
9.Go to “Completing the parts replacement” on page 57.
Replacing the rear fan assembly
Attention
Do not open your server or attempt any repair before reading and understanding the Chapter 1 “About this manual” on page 1 and the Safety Information book. To obtain a copy of the Safety Information book, go to:http://www.lenovo.com/support
This section provides instructions on how to replace the rear fan assembly.
To replace the rear fan assembly, do the following:
1.Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the server.
2.Remove the server cover. See “Removing the server cover” on page 30.
3.Locate the rear fan assembly. See “Internal components” on page 26.
Chapter 6. Replacing FRUs 55
