7. THE FOLLOWING MUST BE APPLIED WHEN FIXING THE HEATER TO THE WALL BRACKET
i)If no skirting board is present secure the heater through the wall bracket slots closest to the wall.
ii)If 100mm (4in.) skirting is present secure the heater through
the outer slots.
iii)If skirting taller than 150mm (6in.) is present this must be reduced to 150mm (6in.) over the entire width of the heater plus 25mm (1in.) at each end.
Do not fully tighten these screws until the bricks are loaded into the heater as some settling of the heater may occur.
NOTE: NEVER REMOVE THESE SCREWS WITHOUT FIRST UNLOADING THE HEATER.
12.
13. Fit the front bricks again with the recess towards the element.
7.
8. Remove the front panel by removing the two self tapping screws along its bottom edge. With hands positioned on each side of the panel, lift upwards to unhook the top edge whilst pressing down on the top panel with your thumbs. The panel can now be lifted clear and set to one side. Discard the packing which had been sandwiched between the inner front and outer front.
8.
14. Replace the inner front complete with insulation by locating its bottom edge behind the front lip of the
chassis and inserting retaining screws along both sides.
15. Feed the mains cable through the cable clamp and make connections as marked on heater. Pull back any slack
through the clamp and tighten clamping screw.
WARNING
This appliance must be earthed
15.
9. Remove the inner front by removing the screws along its sides. As the front insulation is attached care must be taken when lifting this panel from the heater and placing it to one side. Remove the internal packing by sliding it up and off the
elements taking care not to damage the insulation.
9. |
| 10. |
|
|
|
10. Remove the element to allow access for the back rows of bricks. Loosen the two screws securing the element tails in the ceramic
connectorblock,andlifttheelementupandoutoftheheater.
16. Replace outer front panel and grille by hooking the grille into its retaining slot on the top panel and lowering it into position. Secure the front panel with the two self tapping
screws.
16.
11. Carefully fit the bottom rear brick with the narrow end of the recess over the slot in the base insulation. Fit the top
rear brick with the narrow end of the recess to the top.
12. Refit the element which had been removed by feeding the tails down through the hole in the base insulation and into the connector block. Ensure the element is fully pushed home
then securely tighten the two screws in the block.
17. Check that the screws securing the heater to the wall bracket have been fully tightened.
IT IS ESSENTIAL THAT ALL SCREWS ARE REPLACED TO ENSURE EARTH CONTINUITY.
Once installed do not attempt to reposition the heater without first obtaining the services of a competent electrician.
