page. Always use the same gauge wire for the amplifier ground that you use for the power wire. Be sure to examine the battery ground cable of the vehicle, and if neces- sary, upgrade it by adding an addi- tional ground wire that is the same gauge as the amplifier's power wire. Remember, the amplifier can only deliver its rated output when it is not current limited by the power and ground supply wires.
8.This amplifier is designed to drive a speaker load that measures from 2 to 8 ohms (1 ohm on D2205 Sub Output). Keep in mind that heat is the
9.Battery and ground connections to the vehicle should be made with crimped ring terminals of the appro- priate size (surface area is what counts); soldering the terminals after crimping is also recommended.
10.Due to the
FRONT PANEL CONNECTIONS/STATUS LED
1.ESP® Port - connection port for Bitwriter® or ESP2 security system.
2.ESP® Status LED - indicates ESP® functionality and is used to diag- nose ESP® features.
3.RCA Input Jacks - accepts line level outputs from head units or signal
processors at voltages between 250 mV and 7.5 volts. (A1004 and D2205 also have a Rear Input.)
4.RCA Output Jacks - these pass through RCA jacks can be used to send a signal to a second amplifier.
6 | © 2004 Directed Electronics, Inc |