NOTE
Prior to servicing your vehicle ensure that the alarm system is disarmed. Due to the amplifier’s
If the alarm is replaced with another ESP2 alarm system, ensure that the amplifier goes through a learn routine (using the Bitwriter®) prior to re- enabling the
INSTALLATION GUIDELINES
1.Please read this owner's manual care- fully before installing this amplifier.
2.Disconnect the battery ground terminal prior to making any elec- trical connections.
3.Check for any hazards or obstruc- tions such as gas tanks, fuel or brake lines, and wiring harnesses before mounting the amplifier.
4.Pick a mounting location that will provide adequate access and venti- lation and protect the amplifier from heat, moisture, and dirt.
5.Avoid sharp metal areas when routing cables to the amplifier, and run RCA cables away from the power cables and other potentially noisy car harnesses.
6.The amplifier should be grounded with a short, heavy gauge wire
connected directly to the car at a bare metal surface, preferably scraped body sheet metal. Do not use factory grounded locations, seat bolts, or brackets that are spotwelded.
7.Always fuse your power connection within in 8 to 10 inches of the battery terminal. Use a fuse or circuit breaker rated slightly more than the
© 2004 Directed Electronics, Inc | 5 |
