Basic Operation

The RC100 can control the functions of the MCB 1000 zone monitors, the TVM300 TV tuner, the VC2010 VCR, and the VC2050 VCR.

To operate a specific monitor, the remote controls zone button (4) for that monitor must first be selected.

TURN THE MCB1000 ON/OFF

■Press the MAIN POWER (1) button to turn the MCB1000 on/off.

TURN ZONE MONITORS ON/OFF

■Press the ZONE (4) button for the monitor you want to turn on.

■Press the PWR/SOURCE (2) button to turn the monitor on. Press the PWR/SOURCE

(2) button for more than three seconds to turn the monitor off.

SELECTING A SOURCE

■With the zone monitor on, press the PWR/SOURCE (2) button for less than three seconds to toggle through all connected video sources.

PROGRAMMING MENU

■All on-screen programming can be performed using the MENU/ADJUST (5) buttons. Refer to the On-screen Programming section for programming information.

AUDIO THROUGH VEHICLE SOUND SYSTEM

■Only available with the RFM100 connected.

■Select the zone that the RFM100 is connected to. Press the FM MOD (3) button. Set the vehicles radio to the correct frequency and the audio from that source will be heard through the vehicles sound system.

USING THE TV TUNER

MEMORIZING CHANNELS

■With the TV tuner as the source, press the CHDN/CHUP (7) buttons. The channel will move up or down one channel at a time. Press and hold to tune through channels at a rapid rate.

CHANGING CHANNELS

■With the TV tuner as the source, press the AUTO MEM (8) button. The TV tuner will start searching for stations, adding to memory any channels within reception range.

NUMERIC BUTTONS

■Channels can be directly selected by using the Numeric (6) buttons. When the channel number is selected, it will appear on the screen for a few seconds then the TV tuner will change to the selected channel.

ANTENNA/CATV

■When in an area where cable is available the TVM300 can accept up to 125 channels of CATV input. Refer to the programming menu to change from Antenna to CATV.

8

© 2001 Directed Electronics, Inc.