TOOL REQUIRED: PHILLIPS SCREWDRIVER
Stand base in upright position. Push midsection onto base by aligning tabs on the backside of midsection with the pockets on the backside of base. One at a time, place nut into recess located on the back of the left, right and middle back of the base. While holding nut in place, insert screw through front of midsection and tighten. Repeat this process with the remaining two (2) nuts and screws. NOTE: Make sure the power cord is out of the way to avoid pinching.
Slide upper handle down onto unit. Place nut into recess in back of upper handle. While holdina nut in dace. insert screw throughfront of'upp& han- dle and tighten. Route cord above upper cord hook and snap into cord clip on upper handle.
