4
3
Press RECORD on the remote control:
222.book Page 59 Tuesday, July 25, 2006 1:30 PM
Remote Controls
Improving Receiver Control
Checking the Remote Control Address
You can see what address is programmed into the remote control by completing the following instructions.
1 Press and hold the SAT mode button for three seconds, until all of the mode buttons light up, and then let go of the SAT button.
2 Press POUND (#) twice. The SAT mode button will flash the same number of times as the address number (three flashes means address 3).
Confirming Remote Control Operation
Complete the following from the nearby TV to make sure the remote operates the receiver:
1 Make sure the remote has fresh batteries and is in SAT mode.
2 Press SYSTEM INFO on the receiver front panel to display the System Info screen on the nearby TV.
•Remote Control 1 - The Primary Remote Address in the System Info screen changes to match the address preset in your remote control.
•Remote Control 2 - The Secondary Remote Address in the System Info screen changes to match the address preset in your remote control.
Press POWER on the remote controls to turn on/off receiver.
59
