dIXEL | Operating Instructions XWA11V | 1598003200 |
|
|
|
2.2
SAFETY PRECAUTIONS
•Check if the supply voltage is correct before connecting the instrument.
•Do not expose the back of the instrument to water or moisture: use the controller only within the operating limits avoiding sudden temperature changes with high atmospheric humidity to prevent the formation of condensation.
•Warning: disconnect all electrical connections before performing any maintenance operation.
•Fit the probe where it is not damaged by the
•In case of failure or faulty operation send the instrument back to the distributor (see address) with a detailed description of the fault.
•Consider the maximum current that can be applied to each relay (see Technical Data).
•Ensure that the wires for probes, loads and the power supply are separated and far enough from each other, without crossing or intertwining.
3. INTERFACE
LOW HIGH
KEY
HIGH
FRONT PANEL OPERATION
In Programming Mode press to select a parameter or to confirm an operation. Press and hold this key for more than 5 s to turn the controller OFF.
Press and hold this key for more than 1 s to turn the controller back ON.
Press to see the HIGH Temp ALARM (ALU parameter)
LOW
Press to see the LOW Temp ALARM (ALL parameter)
In Programming Mode press to browse parameter codes. Press to increase the displayed value.
Press to mute the buzzer (+ relay) when an ALARM is happening.
Hot key programming: with the instrument on, insert the hot key and then press the UP button.
In Programming Mode press to browse parameter codes. Press to decreases the displayed value.
Switch ON and OFF the light of the cold room
KEY COMBINATIONS: PRESS SIMULTANEOUSLY
+ | To lock and unlock the Keyboard. |
+ | To enter the Programming Mode. |
Weiss Instruments, Inc. 905 Waverly Ave. Holtsville, NY 11742 | 2 |
