Dixon 3500 Series manual Specifications, Model ZTR 3530

SPECIFICATIONS

Model ZTR 3530 & 3536

CHASSIS:	1X2X11 gauge welded tube, 7 gauge transmission and engine
	base plate.
BODY:	All body parts made of high density polyethylene. Dent and corrosion
	resistant.
MOWER DECK:	30” Deck: 11 GA Stamped Steel Construction-30” Cut Width.
	36” Deck: 11 GA Fabricated Construction/Reinforcement Ribs-36”
	Cut Width. Cut height approximately 1” to 4” via 7 position lift handle.
BLADE DRIVE:	Electric clutch.
TRANSMISSION:	Each rear wheel is independently driven by a HydroGear IZT
	hydrostatic drive.
ENGINE:
Model 3530:	13.5 HP Briggs & Stratton Intek, 4-Cycle, Single Cylinder, Overhead
	Valve, Air-Cooled, Gasoline, Vertical Shaft with Cast Iron Cylinder
	Sleeve, pressure lube with spin-on filter.
Model 3536:	14.5 HP Briggs & Stratton Intek, 4-Cycle, Single Cylinder, Overhead
	Valve, Air-Cooled, Gasoline, Vertical Shaft with Cast Iron Cylinder
	Sleeve, pressure lube with spin-on filter.
STARTING	Electric by key switch operation with safety interlock blade and
SYSTEM :	traction drive.
TIRES:	Front	11 x 4.00 x 5 ribbed tread
	Rear	18 x 8.50 x 8 (3536)
	Rear	18 x 7.00 x 8 Multi Trac (3530)
RECOMMENDED	Front	16-21 PSI
TIRE PRESSURE:	Rear	8-14 PSI
CAPACITIES:	Fuel	3.3 gallons total
	Engine	1.5 quarts oil
DIMENSIONS:	Width	44” maximum track width
	Height	42” to top edge of seat
	Length	73” hitch tab to front bumper
	Weight	3530 - 512 lbs	3536 - 554 lbs.

Additional information provided in service instructions under the individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

13