ASSEMBLY
7 INSTALLING CHUTE SUPPORT
3 Bin System only
1.Position upper chute support against bagger inlet, flush at outer edges. See Illlustration.
2.Using support as a template, drill two 3/8" holes into bagger hood.
UPPER CHUTE
SUPPORT
BAGGER
HOOD
BAGGER INLET
3.Secure upper chute support to hood with hex bolts, washers and nyloc nuts.
FLEX TRIM
NUT
HEX BOLT
FLAT WASHERS
8 INSTALLING WEIGHT KITS Units with cast weight
1.Bolt one cast weight and two weight brackets together using four 2¾" bolts and four nuts.
2.Slide both weight brackets over the front tube on the frame, positioning the assembly in the center of the frame.
3.Secure with four 3¾" bolts and four nuts.
CAST WEIGHT | FRONT TUBE |
3¾ BOLT
2¾ BOLT
NUT 
WEIGHT BRACKET
RAM 44
Units with two or more weight plates
1.Bolt weight plates to weight brackets using four 1¾" bolts and four nuts.
2.Slide both weight brackets over the front tube on the frame, positioning the assembly in the center of the frame.
3.Secure with four 2¾" bolts and four nuts.
FRONT TUBE
WEIGHT PLATES
2¾ BOLT
WEIGHT BRACKET
1¾ BOLT
RAM 50
12
