ASSEMBLY
1INSTALLING DRIVE PULLEY
1.Remove the discharge chute from the deck. (Deck configuration will vary by size and model)
2.Lower deck to the lowest cutting position.
3.Remove the right hand (discharge side) belt cover from the deck.
4.Relieve the tension from the deck belt and remove from the center deck pulley.
(See Operator’s Manual if necessary)
DECK HEIGHT ADJUSTMENT
5.Remove the bolt that secures the right hand deck pulley to the spindle.
6.Replace right blade shaft with new, longer shaft. The existing drive pulley and key will fit on the new shaft. Install blower drive pulley with the raised portion of pulley hub down. Slide spacer inside new pulley. Add key to new pulley.
7.Remove two rear bolts from spindle and place belt shield standoff where the two bolts were removed. Replace bolts and tighten.
8.Use heavy washer and bolt supplied in kit to attach pulley to spindle. Torque to
9.Reinstall the deck belt.
NEW BOLT
NEW HEAVY WASHER
DRIVE PULLEY
DISCHARGE CHUTE
BELT COVER
| SPACER |
BELT SHIELD | SPINDLE |
STANDOFF |
KEY
REPLACEMENT SHAFT
8
