CONTROLS
MOWER DECK CUT HEIGHT LIFT LEVER
• Located to the right and front of the
operator.Trigger
•Controls the cutting height.
•17 positions of adjustment
•Depress trigger and move lever forward to lower deck.
•Pull lever back to raise deck.
•Set desired cut height with pin.
•Use foot pedal to assist with raising and lowering deck.
Pin
Each hole provides a different cut height adjustment
Foot Pedal
NOTE: | Always use high position for transport. |
The two holes at the front of the quadrant are for 1½" (38mm) and 1¾"(44mm) cut heights.
The four holes along the bottom of the quadrant are for one inch cut height increments— 2" (51mm) to 5" (125mm).
The second row of holes from the bottom are for an additional ¼" (6mm) of cut height over its mating one inch increment — 2¼" (57 mm) to 5¼" (133mm).
The third row of holes from the bottom are for an additional ½" (12mm) of cut height over its mating one
inch increment
The remaining three holes are for an additional ¾" (19mm) of cut height over their
mating one inch increments —
5" (125mm)
4" (102mm)
3" (76mm)
2¾" (70mm)
to 4¾" (120mm).
2" (51mm)
21
