Dixon ZTR 5423 manual Chassis

	SPECIFICATIONS
	Model ZTR 5601
CHASSIS:	11 GA - rectangular tube
BODY:	Two piece - made of rotational molded polyethylene. Front body contains
	access panels for battery service and engine to mower deck belt removal. Rear
	body tilts up to allow service on the entire drive system.

SEAT:

MOWER DECK:

Ergonomically designed for operator comfort by use of high density closed cell foam, contoured back rest and arm rests. Seat is adjustable fore and aft.

1 0 GA stamped steel construction 3 blades combine for 60" cut width Cut height approximately 1 " to 4" via 8 position lift handle

BLADE DRIVE: DRIVE SYSTEM:

ENGINE:

STARTING SYSTEM:

TIRES:

RECOMMENDED TIRE PRESSURE:

CAPACITIES:

DIMENSIONS:

NOTE:

Electric clutch

Each rear wheel is independently driven by a HydroGear BDU-10L Series 70 hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully enclosed HydroGear gearbox.

22HP Kohler Command, 4-Cycle, V-Configuration, Overhead Valve, Air-Cooled, Gasoline, Horizontal and Vertical Shaft, Aluminum Head, and Crankcase with Cast Iron Liners, Full Pressure Lubrication/Full Flow Filter, Pulse-type Fuel Pump, Fixed Jet Carburetor w/Smart-Choke, Electronic Ignition, In-Line Fuel Filter, Dual Element Air Cleaner.

Electric by key switch operation with safety interlocks on parking brake and blade drive clutch.

Front	1 1 X 4 X 5 ribbed tread
Rear	20 X 1 0 X 8 Multi Trac
Front	16-21lbs.
Rear	8-14lbs.

Fuel - 4.8 gallons total (dual tanks) , Hydrostat oil tank

-3 quart with in-line 1 0 micron filter Hydrostat oil recommendation, refer to page 37 Engine - 2 qts. SAE 10W30 (with filter)

Width	72"
Height	45"
Length	72"
Weight	685 Ibs.

Additional information provided in service instructions underthe individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

Page 10