Dixon ZTR 5423 manual Model ZTR

CHASSIS:

BODY:

SEAT:

MOWER DECK:

BLADE DRIVE: DRIVE SYSTEM:

ENGINE:

STARTING SYSTEM:

TIRES:

RECOMMENDED TIRE PRESSURE:

CAPACITIES:

DIMENSIONS:

NOTE:

SPECIFICATIONS

Model ZTR 5502

1 1 GA - rectangular tube

Two piece - made of rotational molded polyethylene. Front body contains access panels for battery service and engine to mower deck belt removal. Rear body tilts up to allow service on the entire drive system.

Economically designed for operator comfort by use of high density closed cell foam, contoured back rest and arm rests. Seat is adjustable fore and aft.

1 1 GA fabricated welded construction with external reinforcement ribs 3 blades combine for a 50" cut width Cut height approximately 1 .5" to 4.5" via 8 position lift handle

Electric clutch

Each rear wheel is independently driven by a HydroGear BDU-10L Series 70 hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully enclosed HydroGear gearbox.

20HPKohler Command, 4-Cycle,V-Configuration, Overhead Valve, Air-Cooled, Gasoline, Horizontal and Vertical Shaft, Aluminum Head, and Crankcase with Cast Iron Liners, Full Pressure Lubrication/Full Flow Filter, Pulse-type Fuel Pump, Fixed Jet Carburetor w/Smart-Choke, Electronic Ignition, In-Line Fuel Filter, Dual Element" Air Cleaner.

Electric by key switch operation with safety interlocks on parking brake and blade drive clutch.

Front	1 1 X 4 X 5 smooth profile
Rear	20 X 10 X8 Multi Trac
Front	16-21	Ibs.
Rear	8 - 14	Ibs.

Fuel - 4.8 gallons total (dual tanks) Hydrostat oil tank - 3 quart with in-line 10 micron filter Hydrostat oil recommendation, refer to page 37 Engine - 2 qts. SAE 1 0W30 (with filter)

Width	60"
Height	45"
Length	72"
Weight	680 Ibs.

Additional information provided in service instructions underthe individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

Page 9