DKS Enterprises 1812 PLUS SECTION 1

SECTION 1 - INSTALLATION

Installation of the 1812 Plus Telephone Entry System involves the installation of the hardware and by-

pass switch, and the wiring of these components.

If used to control a vehicular gate with an automatic gate operator, the

telephone entry system must be mounted a minimum of ten (10) feet away

from the gate and gate operator, or in such a way that a person cannot

operate the entry system and/or touch the gate or gate operator at the same

time.

Surface and Wall mount units can be mounted directly to a wall or pilaster or post mounted using a

DoorKing mounting post (there are several different styles available). Flush mount units are designed

to be mounted into a pilaster, wall or kiosk. In any case, be sure that the unit is securely mounted

and is not subject to continuous vibration from closing doors or gates.

1. Open the cabinet of the 1812 and carefully disconnect the front panel terminal connector

and the keypad connector. The front panel terminal connector is located in the lower right

hand corner. The entire connector will come off the board by gently pulling it straight out.

2. Remove four (4) 6-32 a 1/2 round head screws from each corner of the control board.

3. Remove the control board from the housing. CAUTION: The control board contains static

sensitive components. Discharge any static electricity from your hands by touching a

proper ground device before removing the control board.

4. Mount the 1812 housing assembly. Make any conduit connections at this time. Be sure

that the mounting screws do not protrude into the cabinet where they could cause a

short.

5. Route wiring into the housing assembly at this time. DO NOT APPLY POWER.

6. Clean out the back box. Be sure that all dirt, metal or wood debris is removed from the

back box.

7. Remove the main terminal wiring connector from the control board by gently pulling it

straight up. This will make wiring to the main terminal easier.

8. Install the control board into the back box. Secure the control board with the four (4) 6-32

x 1/2 screws removed in step 2. CAUTION: The control board contains static sensitive

components. Discharge any static electricity from your hands by touching a proper

ground device before installing the control board.

9. Plug the front panel connector onto the control board pins in the lower right hand corner.

The red wire goes to the left.1

10. Plug the keypad connector onto the circuit board plug. The cable points down.

11. After pre-wiring the main terminal control board connector (see wiring instructions),

carefully re-install it onto the control board main terminal pins.

1812-161-E-1-10 Page 9