1.6 Chain Installation 1. Secure the chain brackets to each end of the gate so that the brackets will be level with
the chain where it exits the operator.
Brackets should be attached to the inside of
the frame so that the chain bolts, when
attached, do not protrude beyond the frame
of the gate.
2. Route the chain through the gate operator.
3. Attach the chain to the chain bolts using the
master links supplied, and then attach the
chain bolts to the chain brackets using the
hardware supplied. Make any adjustments to
the chain length at this time.
4. Adjust the chain bolts to tighten the chain.
The chain should sag no more than one (1)
inch per 10 feet of travel. Do not over tighten the chain. IMPORTANT!! Be sure that the
chain is parallel to the gate. Installing the chain in any other manner will cause
excessive noise, chain idler wear and chain stretching.
Page 22 9210-065-H-8-08