5.4 Accessories
The following accessory items can be used with the model 9210 / 9230 slide gate operator.
Contact Sensor Contact sensors for use as a secondary entrapment protection device.
Miller Edge, Inc. ME120, ME123, MG020, MGR20, MGS20
Photo Cell Non-contact (photo cells) sensors for use as a secondary entrapment
protection device – Listed to UL 325.
Infrared Thru-Beam with hood and built-in heater. 165-foot range.
P/N 8080-010
Photo-Reflective. 30-foot range.
P/N 8080-011
Infrared Thru-Beam. 65-foot range.
P/N 8080-031
Poloraized Photo-Reflective. 35-foot range.
P/N 8080-030
Loop Detector Detectors plug directly into ports on circuit board simplifying wiring.
P/N 9410-010 - Single channel detector.
P/N 9409-010 - Two channel detector
Loop Wire 18 AWG loop wire with XLPE insulation is ideal for ground loops.
Available in 500 and 1000 foot rolls with red, blue or black insulation.
Pre-Fab Loops Prefabricated ground loops. 24-foot circumference with 50-foot lead-in.
Available in yellow, red or blue jackets. Not for use in asphalt roadways.
Loop Test Meter Meg-ohm meter checks the integrity of ground loops.
P/N 9401-045
Control Station Three button interior and exterior control stations provide manual open-
close-stop gate operation.
P/N 1200-006 – Exterior / Interior
P/N 1200-007 - Interior
Time Clock 7 day and 365 day time clocks can be used to automatically open gate at
pre-set time and days. Compact clock fits inside the operator.
P/N 2600-791 – 7-day clock.
P/N 2600-795 – 365-day clock.
Surge Devices High and low voltage surge suppressers help prevent circuit board failure
caused by lightning strikes and power surges.
P/N 1876-010 - High Voltage.
P/N 1878-010 - Low Voltage.
Gate Scale Use to test ft/pounds required to move gate. P/N 2600-225
Speed Bumps Prefabricated six-foot speed bump reduces traffic speed through gate
system. P/N 1610-150
Mounting Stand Heavy-duty pedestal mounting stand for the 9210 operator.
P/N 9200-135
Remote Reset Remote reset control station includes both audio and visual alarms to
indicate gate operator is in a hard-shutdown condition. Also provides a
reset button to reset the operator.
P/N 1404-080
Traffic Signal Red / Green traffic signal is synchronized with the movement of the gate
and alerts drivers when it is safe to proceed.
P/N 1603-208
9210-065-H-8-08 Page 49