SECTION 3 - ADJUSTMENTS
The switch settings and adjustments in this chapter should be made after your installation and wiring
to the operator(s) is complete. Whenever any of the programming switches on the circuit board are
changed, power must be shut-off, and then turned back on for the new setting to take effect.

3.1 Circuit Board Adjustments

Set the DIP-switches on the circuit board to the desired setting. See switch-setting charts in section
3.2.
Auto close timer (when turned on) can be set from 1 second (full counter clockwise) to approximately
23 seconds (full clockwise).
Dry contact relay (terminals 11-12) can be set for Normally Open (NO) or Normally Closed (NC)
operation by placing the relay shorting bar on the NO or NC pins respectively.

Power LED indicates that low voltage power is applied to the circuit board.

Input LEDs should be OFF and will only illuminate when the input is activated.

The limit LED will be ON when the respective limit switch is activated.

111 10 9 8 7 6 5 4 3 220 19 18 17 16 15 14 13 12
TIME
DELAY
REV SENS
OPEN
REV SENS
CLOSE
REVERSE
LOOP
RELAY CONTACT
REVERSING DEVICE
CONNECTOR
P5
ON
4 3 2 1 8 7 6 5 4 3 2 1
EXIT
LOOP
LIMIT SWITCH
CONNECTOR
LMT
POWER
P4
P6
9210-065-H-8-08 Page 33