![](/images/new-backgrounds/1252710/25271037x1.webp)
4 6
5
4
1
3
2
Thread the harness down through slot on left side of shell (1), across bottom of shell (2) and up through slot on right side (3).
Thread one latch plate onto harness from back to front (4). Thread the harness retainer (5). Do the same to the other harness end. Make sure the harness is not twisted.
Push harness ends through upper slots in shell (6).
Removing Seat Pad for Cleaning
!WARNING
Do not use this child restraint without the seat pad. Failure to do this can result in serious injury.
1 | Remove harness as |
described in the “Belt- | |
| Positioning Booster” |
| section. |
5 |
Fit loops on harness ends onto the splitter plate.
If your child restraint has armrests, pull armrest covers off armrests and pull through hole in back of shell.
2 | From underneath bottom | |
of shell, release the elastic | ||
| ||
| straps shown in red. |
!WARNING
Failure to reattach the harness correctly, can result in serious injury or death.
34 | 35 | continued on next page. |