3 | Thread both portions of |
the vehicle belt onto the | |
| locking clip. |
Trouble Shooting
1. If your child restraint is not held securely |
by the belt: |
Press down firmly on the child restraint and remove all the |
slack in the belt. Make sure the belt buckle is not up against |
the child restraint where the belt cannot be tightened. |
Review Locking Clip section and Top Anchorage Strap |
Section. If you cannot secure the child restraint tightly, |
move it to another seating location. |
2. If the child restraint buckle or harness |
release lever sticks or you cannot get the |
4 |
Position locking clip about 1 in. (2.5 cm) from vehicle belt’s buckle plate.
straps tight enough around child: |
DO NOT LUBRICATE. Check around buckle and harness |
release lever for dropped food, sticky spilled drinks, dirt, |
leaves, etc. Clean with warm water and/or remove object |
with tweezers. If you cannot get the harness to adjust and |
remain tight with the buckle securely locked, do not use |
the child restraint. |
3. If your harness twists or ropes: |
Straighten the harness each time you put your child in the seat to help prevent twisting. Lock the buckle and tighten harness and it will be ready for next use.
5 | Rebuckle belt. Lap belt | |
portion should now be | ||
| ||
| tight. If not, remove | |
| locking clip and repeat all | |
| steps. |
4.In
Remove all the slack in the vehicle belt. Make sure the belt buckle is not up against the child restraint where the belt cannot be tightened. If you cannot secure the child restraint tightly, move it to another seating location.
5.In
Try moving the child restraint toward the center of vehicle or move the vehicle seat forward or back. Check to see if your vehicle has adjustable shoulder belt anchor points. Do Not place the shoulder belt behind the child.
38 | 39 |
