Dorel Eng. 4358-5936 manual Install Cup Holder on select models, Check Harness Height, Front

5

6

Harness

Guide

Place the child’s bottom and back flat against the child restraint. This will increase comfort and allow the harness to properly tighten.

Check Harness Height

Forward-Facing Position: Harness guide must be even with or just above the shoulders.

If the top harness guides are below the child’s shoulders, the child weighs at least 40 lbs. (18.1

9	Pull harness through the
	harness guides from the
	front.

Rethread harness into new harness guide location. Refasten harness to splitter plate. Make sure harness does not twist.

!WARNING

Failure to reattach the harness correctly can result in serious injury or death.

Install Cup Holder (on select models)

kg) and is over 1 year old, convert the seat to a belt- positioning booster.

1

Pull pad off corner. Hook bottom of cup holder on bottom edge of child restraint and rotate cup holder up.

7

8

Determine which set of harness guide slots works best for your child. Adjust if needed.

To change harness location:

From the back of the seat, remove harness from splitter plate.

2

Snap top of cup holder on top edge of child restraint. Make certain cup holder is flush on the top and sides of child restraint. Replace pad.

12

13