Wayne-Dalton 46 TorqueMaster Spring Tube, Center Bracket Bushing, Installation

17	TorqueMaster® Spring Tube
Tools Needed:	TorqueMaster® springs come lubricated
None	and pre-assembled inside the
	TorqueMaster® spring tube. To install, lay
	the TorqueMaster® spring tube on the
	floor (inside garage) in front of the door
	with the labeled end to the left.
	IMPORTANT: Right and left hand is
	always determined from inside the
	garage looking out.

TorqueMaster®

Spring Tube

LABELED END

18	Center Bracket Bushing		CENTER
			BRACKET
Tools Needed:	NOTE: If you are installing an idrive®		ASSEMBLY
None	opener on your garage door, skip this
	step and continue with Step 19.
	NOTE: If you are not installing an idrive®	TorqueMaster	®
	opener on your garage door, you must
		Spring Tube
	install the center bracket bushing
	assembly. Follow these instructions for
	non-idrive®operated garage doors.
	NOTE: If you are installing a
	DoorMaster™ opener, see optional		TorqueMaster®
	DoorMaster™ Bracket installations on
	page 33, figure A.		Spring Tube

Being cam shaped the center bracket bushing only fits one way.

Slide the center bracket assembly towards the center of the torque tube, from the right side as shown.

NOTE: Upon completion of this step,	CENTER
	BRACKET
continue with Step 20.	BUSHING

21

INSTALLATION

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com