Wayne-Dalton 46 Trolley Operator, Be Tested At The Same, Does Not Close And A, Injury

�	Trolley Operator
Tools Needed:	WARNING
Tape Measure	OPERATOR MUST BE TESTED
	AT TIME OF INSTALLATION AND
Power Drill	MONTHLY THEREAFTER TO
7/16” Socket	ENSURE THAT DOOR REVERSES
	ON CONTACT WITH 2 X 4 BOARD
Driver	LAID FLAT UNDER THE DOOR.
	FAILURE TO ADJUST OPERATOR,
	IF NECESSARY, CAN RESULT IN
	SEVERE OR FATAL INJURY. IF
	YOUR OPERATOR IS EQUIPPED
	WITH A PHOTOELECTRIC EYE
	SYSTEM, THEN THIS MUST
	BE TESTED AT THE SAME
	TIME TO ENSURE THAT DOOR
	DOES NOT CLOSE AND A
	CLOSING DOOR OPENS IF
	PHOTOELECTRIC EYE SYSTEM IS
	OBSTRUCTED. FAILURE TO MAKE
	ADJUSTMENTS, IF NECESSARY,
	CAN RESULT IN SEVERE OR FATAL
	INJURY.
	1. Install operator rail 1/2” to 1-1/2”
	(13 - 38 mm) above high arc of top
	section of the door.
	2. Mount operator to ceiling so that
	1” to 1-1/2” (25 - 38 mm)
	clearance is maintained between
	trolley rail and top section when
	door is fully open (trolley rail will
	slope down towards rear).
	3. Attach door arm to operator
	bracket.
	4. Attach operator rail to suitable
	mounting surface 2x6 lumber
	minimum.
	5. Attach operator to ceiling using
	perforated angle.
	IMPORTANT: perforated Angles
	must be securely attached to
	sound framing member(s).

OPERATOR RAIL

SUITABLE MOUNTING

SURFACE 2X6

LUMBER MINIMUM

HEADER

DOOR ARM TO

OPERATOR BRACKET

perforated

OPERATORangle rail

OPERATOR

FRAMING MEMBERS

PERFORATED ANGLE

optional INSTALLATION

35

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com