Wayne-Dalton 46 installation instructions optional INSTALLATION, Side Lock, DoorMasterTM Bracket

�	Side Lock
Tools Needed:	Install the side lock on the second
Power Drill	section of the door. Secure the lock to
	the section with (4) 1/4”- 20 x 11/16”
7/16” Socket	self drilling screws. Square the lock
Driver
	assembly with the door section and
Tape Measure
	align with the square hole in the vertical
	track. The side lock should be spaced
	in approximately 1/8” from the section
	edge.
	IMPORTANT: side locks must be
	removed or made inoperative in
	the unlocked position if an
	operator is installed on the
	door.
	NOTE: After completing this step,
	continue with Step 13 on page 19.

(4) 1/4”- 20 x 11/16”
self drilling screws	1/8”

�	DoorMasterTM Bracket	a
		DoormasterTM bRACKET/
		DRIVE GEAR ASSEMBLY
	A
Tools Needed:
	NOTE: When installing a DoorMasterTM
	operator use the center bracket and
	drive gear supplied with your operator
	(located in DoorMasterTM package).
	Slide the DoorMasterTM bracket/drive
	gear assembly onto the TorqueMaster®
	spring tube, so that the drive gear/center
	bracket assembly are in the center of
	the TorqueMaster® spring tube.
	NOTE: After completing this step,	Torquemaster® tube
	continue with step 20 on page 23.
Tools Needed:	B	b
Power Drill	Locate the center bracket, mark the	DoormasterTM
	header halfway between the flagangles
		bRACKET/ DRIVE
	and level the TorqueMaster® spring
		GEAR ASSEMBLY
1/8” Drill Bit	tube. Drill 1/8” pilot holes for the lag
	screws. Fasten the metal bracket to the
7/16” Socket	header using (2) 1/4” x 1-1/2” hex head
	lag screws.
Driver
Tape Measure	NOTE: After completing this step,
	continue with step 29 on page 29.
		(2) 1/4” x 1-1/2” hex
Level
		head lag screws

33

optional INSTALLATION

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com