Wayne-Dalton 46 installation instructions Hinges

5		3
	Hinges	1
		2
Tools Needed:	Locate the lower (numbered) leaf of	4
Power Drill	the #1 end hinges and required center	5
	hinges over the #1 and #4 holes in the	6
7/16” Socket	end stiles for the end hinges and the
	pre-punched holes in the center stile(s)
Driver
	for the center hinges at the top of the
					roller
	section.	7			placement
	NOTE: The #1 hinges serve as end
	hinges on the bottom section. The #1			#1 Hinge	#2 End Hinge
	hinges also serve as center hinges at all
	center hinge locations.
	Secure the hinges to the section using
	(2) 1/4”-14 x 5/8” self tapping screws
	on each hinge leaf.
	Insert roller into appropriate hinge tube.
	Repeat for all other sections using the
	#2 end hinges on the second (lock				roller
	section) and the #3 end hinges on the				placement
	third section (intermediate section).	end stile hole		roller
		pattern	center stile	placement
	NOTE: #4 End hinges are used on fourth	(LEft side is shown.
			hole pattern
	section of five section doors.	right side is		#3 End Hinge	#4 End Hinge
		opposite.)
	IMPORTANT: When placing rollers
	into end hinges number 2 and
	higher, the roller goes into the
	tube furthest away from section.
		#1 hole		hinge
	IMPORTANT: once fastener is
	snug against hinge leaf, tighten	#4 hole
	an additional 1/4 to 1/2 turn to
	receive maximum design holding
	power.				(2) 1/4”-14 x 5/8”
		end stile
					self tapping
					screws
			end hinge placement
				hinge
			center stile		(2) 1/4”-14 x 5/8”
					self tapping
					screws
			center hinge placement
14

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com