Wayne-Dalton 46 installation instructions Drum Wrap Installation

33	Drum Wrap Installation
Tools Needed:	Drum wraps are identified as right and
None	left hand.
	To install, place the drum wrap over the
	cable drum and under the idrive®
	disconnect cable (right hand side). Align
	the outside flange over the outside edge
	of the cable drum and push the drum	Cable
	wrap down onto the cable drum. Repeat	Drum
	for left hand side.

NOTE: Drum wraps must be installed to prevent cable from becoming tangled.

IMPORTANT: Right and Left hand are always determined from inside the garage looking out.

Cable

Drum

Drum

Wrap

Outside

Flange

Drum

Wrap

INSTALLATION

34	Rear Support
Tools Needed:	WARNING
Ratchet Wrench	Keep horizontal track
	parallel and within 3/4”
1/2” Socket	maximum of door edge,
	otherwise door could fall,
1/2” Wrench	resulting in severe injury or
	death.
(2) Vice Clamps	Raise the door until the top section and
	half of the next section are in a horizontal
Tape Measure	position. Do not raise door any further
	since the horizontal tracks are not yet
Level	supported at the rear.
	WARNING
Hammer
	Raising door further can
	result in door falling and
	cause severe injury or death.
	Clamp a pair of vice clamps on the vertical
	tracks just above the second roller on one
	side and below the second roller on the
	other side. This will prevent the door from
	raising or lowering while installing the rear
	support.
	Using perforated angle, 5/16” x 1-5/8”
	hex head lag screws and 5/16” bolts
	with nuts (may not be supplied), fabricate
	rear support for horizontal tracks. Attach

DOOR IN THE

UP POSITION

door edge 3/4”

horizontal track

vice clamps

vertical

TRACK

31

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com