Wayne-Dalton 46 Step Plate, Pull Rope, Fatal Injury, On Doors With Electric

�	Step Plate
Tools Needed:	Locate the center stile on the bottom
	section of the door.
Pencil	On the outside of the door, position step
1/4” Wrench	plate directly above astragal retainer.
	Using the step plate as a template,
	mark hole locations for mounting on
	door face.
	Drill (2) 5/16” dia. holes through the
	door face and insulation, if necessary, at
	marked locations, being careful to keep
	drill straight.
	Mount step plates back to back,
	straddling stile. Secure with

(2)1/4 x 2-3/4” carriage bolts and 1/4”-

20 flange hex nuts.

NOTE: After completing this step, continue with Step 13 on page 18.

bottom section

step plate

bottom section

step plate assembly

(2) 1/4”-20 flange Hex nut

Inside step plate installation

bottom section

step plate	bottom section
	step plate assembly

(2)1/4 x 2-3/4” carriage bolts

outside step plate installation

�	Pull Rope
Tools Needed:	WARNING
Power Drill	DO NOT INSTALL PULL ROPES
Drill Bit	ON DOORS WITH ELECTRIC
	OPERATORS. CHILDREN MAY
	BECOME ENTANGLED IN THE
	ROPE CAUSING SEVERE OR
	FATAL INJURY.
	Measure and mark the jamb
	approximately 48” to 50” (1220 to 1270

mm)from floor on the right or left side of door. Drill 1/8” pilot hole for No. 6 screw eye. Tie the pull rope to the No. 6 screw eye and to the bottom bracket as shown.

NO. 6 SCREW EYE

PULL ROPE

BOTTOM BRACKET

PULL ROPE

34

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com