29 | Securing Door | |
for Spring Winding | ||
Tools Needed: | Place vice clamps onto both vertical | |
(2) Vice Clamps | tracks just above the third roller. This is | |
to prevent the garage door from raising | ||
| ||
| while winding counterbalance spring(s). |
WARNING
Failure to place vice clamps onto vertical Track can allow door to raise and cause severe or fatal injury.
IMPORTANT: DO NOT USE IMPACT GUN
TO WIND SPRING(S).
place vice
clamps above
3rd Roller
vice clamps | Track | |
attached to | ||
| ||
inner rail |
| |
of track |
|
INSTALLATION
|
| |
30 | Cable Adjustments | |
| ||
|
| |
Tools Needed: | Rotate the cable drum until the set | |
Locking Pliers | screw faces directly away from the | |
| header. TorqueMaster® spring tube cam | |
Flat Tip | peak should be pointing straight up. | |
Screwdriver | Beginning with the right side, loosen | |
| ||
Wire Cutters | the set screw approximately two turns, | |
to adjust cable. Using locking pliers, | ||
| ||
| pull on the end of the cable to remove | |
| all cable slack. | |
| Check to ensure the cable is aligned | |
| and seated in the first groove of the | |
| cable drum. Snug the set screw, then | |
| tighten an additional | |
| excess cable. |
Counterbalance
Cable
Cable
Drum 
Cam Peak
Straight Up
Set Screw
29
Please Do Not Return This Product To The Store. Contact your local
local yellow pages/business listings or go to the Find a Dealer section online at
