Wayne-Dalton 46 installation instructions Vertical Track, Stacking Sections

11	Vertical Track
Tools Needed:	IMPORTANT: The tops of the vertical
	tracks must be level from side
3/16” Drill Bit	to side. If the bottom section was
	shimmed to level it, The vertical
Power Drill	track on the shimmed side, must be
	raised the height of the shim.
7/16” Socket	Position the left hand vertical track
Driver
	assembly over the rollers of the bottom
Tape Measure	section. Make sure the counterbalance
	cable is located between the rollers and
Level	the door jamb. Drill 3/16” pilot holes for the
	lag screws.
	If installing an idrive® opener: Raise the
	track so that the bottom of the track is 1”
	higher than the bottom of the door.
	For non-idrive®operated garage doors:
	Install the track so that it is aligned with
	the bottom of the door.
	Loosely fasten jamb brackets and flagangle
	to the jamb using 5/16” x 1-5/8” hex head
	lag screws. Tighten bottom jamb bracket
	lag screw securely to the jamb to maintain
	5/8” spacing. Hang cable drum over
	flagangle. Repeat for the right side.

JAMB

BRACKET

fLAGANGLE

5/16 x 2” hex

head LAG

SCREWS

VERTICAL

TRACK

ASSEMBLY

BOTTOM SECTION

vertical track

5/8”

roller

flagangle hole

selection

jamb bracket

5/16” x 2” hex head lag screw

12	Stacking Sections
Tools Needed:	NOTE: For door section identification
Power Drill	see page 4.
7/16” Socket	NOTE: Make sure hinges are flipped
	down, when stacking another section
Driver
	on top.
	With assistance, lift second section and
	guide rollers into the vertical tracks.
	Keeping the ends of the sections
	aligned, install remaining section(s),
	except top section, in same manner.
	Now flip up hinge leaf, and fastening
	center hinges first, and end hinges last,
	using (2) 1/4”- 14 x 5/8” self tapping
	screws. Repeat for other section(s)
	except top section.
	NOTE: Install lock at this time (sold
	separately) See instructions in
	OPTIONAL SIDELOCK INSTALLATION on
	page 33.

lock section

18

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com