Wayne-Dalton 46 installation instructions Counter Installation, Securing Center Bracket Bushing

23	Counter Installation
Tools Needed:	Install the right side counter gear, with
None	the missing tooth toward the outside
	and away from the end bracket. Press
	the counter gear onto the end bracket
	until snaps engage.
	Select the right hand counter cover and
	align the hex of the counter cam with
	the end of the winding shaft. Also, align
	the “0” on the counter cover with the
	raised rib on the end bracket. Press the
	counter cover against the counter gear
	until it locks into place.
	Repeat on left hand side for double
	spring applications.
	NOTE: No drive gear, counter gear or
	counter cover is required on left hand
	side for single spring applications. Only
	an end bracket is needed.
	IMPORTANT: At this time do not
	wind Counterbalance Springs!

Raised Rib

Winding

Shaft Inside

End Bracket

Counter

Gear Missing

Tooth Counter

Cover

Hex of the

Counter Cam

INSTALLATION

24	Securing Center Bracket Bushing
		CENTER
Tools Needed:	®	BRACKET
	NOTE: If you are installing an idrive opener on your	ASSEMBLY
Power Drill	garage door, skip this step and continue with Step 25.
3/16” Drill Bit	NOTE: If you are not installing an idrive® opener on
	your garage door, you must install the center bracket
7/16” Socket	bushing assembly. Follow these instructions for
Driver	non-idrive®operated garage doors.

NOTE: If you are installing a DoorMaster™ opener, see optional DoorMaster™ Bracket installations on page 33, Figure B.

IMPORTANT: TorqueMaster® Spring Tube must be level after center bracket assembly is fastened to header.

To locate the center bracket, mark the header halfway
between the flagangles and level the TorqueMaster®
spring tube. Drill pilot holes into header for the lag
screws. Fasten the metal bracket to the header using	(2) 5/16” x 2” hex
(2) 5/16” x 2” hex head lag screws.
	head lag screws

NOTE: Upon completion of this step, continue with

Step 29.

25

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com